The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

la hi · 07-21-2017, 08:33 AM

Thanks for the replies so far. I have a 454 bored out .40, special stainless valves, a comp cam 1102, reworked 700R4.
I am not sure how the torque is going to work on the rearend.
I think I will run it without fenders for a while and find out how the rear end holds up. That's illegal in TX, and I will see how long I can get away with than.
Then I will get help with measuring the fenders by mocking them up and determine the exact width I will need.
Thanks for the step information, I forgot about that.
Keep your ideas coming please.
larry

07-21-2017, 08:33 AM	#14
la hi Registered User Join Date: Oct 2011 Location: Pagosa Springs, CO Posts: 162	Re: fenders need to be wider? Thanks for the replies so far. I have a 454 bored out .40, special stainless valves, a comp cam 1102, reworked 700R4. I am not sure how the torque is going to work on the rearend. I think I will run it without fenders for a while and find out how the rear end holds up. That's illegal in TX, and I will see how long I can get away with than. Then I will get help with measuring the fenders by mocking them up and determine the exact width I will need. Thanks for the step information, I forgot about that. Keep your ideas coming please. larry