|
Re: LMC for cab-to-frame shims?
The shim should have been used by the General on a as needed basis and the new cab mount with a harsh ride quality could be from maybe a different rating of the plyability of the material. I know fro the hundreds of cabs and core supports that I've put on if you tighten the mount too tight it will fail sooner than it should because it will cause the rubber to bulge outward and that is where the failure will start. Now as far as the availibilty go to the lumber store or tractor store and buy some large washers if you are desperate and jack up and install them, not quite as good but just as effective. Jim
|