|
Re: Cab corners
I got some work done. I patched the inner piece. I'm actually very happy at how well that turned out. Bent the edge over in a vise, used pliers as a tucking fork and tucked and hammer and tucked and hammered. I followed you tube and it took a while but I was patient. I did overlap this repair slightly... it just seems to work so much better for me and my little flux core welder. I'll finish it up soon.
As far as the outer corner,...
I can understand why a lap could be a potential rust area... but it will be inside away from water and dirt and so far down into the corner hole it won't be seen. Plus I'll seal it like crazy.
|