[dsraven]

Hey, no prob.
What I meant was the cross dimension check on the stock frame section could be tougher than normal because the front was lopped off so you gotta find/lock some different spots to first establish the stock part is straight and square, then pick some symmetrical points on the welded on clip and do more cross dimensional checks to make sure the clip is parallel to the old frame. It's all just arithmetic but if working off the drawing to figure out where the cab face is, rad support, bumper mounts etc then you have to find the right dimension points in the drawing and combine those because there isn't a direct number in the drawing for some dimensions that you need. Drawing is good, just not terribly straight forward.