Re: Spindle sitting at a angle. Porterbuilt
I just went through the same thing. Caster looked way off so I took it to get aligned, and cast was 14 degrees. Called up PB and they made me take measurements of the upper control arms. They sent me the stock uppers and 1" forward lowers. They did replace the uppers free of charge, but man what a kick in the pants. Had to take them all back apart, and repaint the new ones. I have not been really happy with PB stuff.
The thing I didn't get was that I thought the 1" forward lowers were supposed to work with factory uppers. We could not get caster any lower then 13.0.
Have not had it realigned yet but it does look a lot better.
__________________
68 c10 swb stepper
68 c10 swb stepper
67 c10 lwb
06 gmc duramax
Last edited by 68is4me; 03-10-2018 at 12:58 PM.
|