The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - What to do with hole where Heater Control was located

Arl37 · 01-31-2019, 04:32 PM

Installed a heater delete on outer firewall in my 69 C10.
I would like to fill the hole where the heater controls were located on the dash but don't want weld a plate over the hole.
Believe there are no aftermarket heater control delete plates and it is almost impossible to find an original part.

Appreciate any thoughts about how to fill up the hole.

01-31-2019, 04:32 PM	#1
Arl37 Registered User Join Date: Jul 2011 Location: Valley Center, Ca Posts: 277	What to do with hole where Heater Control was located Installed a heater delete on outer firewall in my 69 C10. I would like to fill the hole where the heater controls were located on the dash but don't want weld a plate over the hole. Believe there are no aftermarket heater control delete plates and it is almost impossible to find an original part. Appreciate any thoughts about how to fill up the hole.