The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

SeventyOne · 11-05-2010, 01:38 AM

the hub wants to rotate inside the rotor a little bit I'm think because the studs are not as wide at the knurls than the stock ones (probably tenths or hundredths of an inch smaller).

Parts are clean (no dirt) and are brand new. I bought the hub and rotor already pressed together with the shorter studs. all surfaces should be to spec.

11-05-2010, 01:38 AM	#58
SeventyOne Registered User Join Date: Mar 2007 Location: Oakland, Ca Posts: 1,362	Re: The "In over my head" build thread the hub wants to rotate inside the rotor a little bit I'm think because the studs are not as wide at the knurls than the stock ones (probably tenths or hundredths of an inch smaller). Parts are clean (no dirt) and are brand new. I bought the hub and rotor already pressed together with the shorter studs. all surfaces should be to spec. Last edited by SeventyOne; 11-05-2010 at 01:39 AM.