[terrylgreenjr]

I talked with Nate and we exchanged measurements of the frame where the notch goes and it is supposed to fit

All the frame measurements for C notch were the same as a truck so I'm thinking the crossmember location measurements would be the same too. What kind of mods do you think the factory crossmeber is going to take? The width and the height of the crossmeber should fit between the frame rails

The driveshaft is a 2 piece and I was trying to see how long the back half is to see if the carrier bearing on my factory shaft in the same place as a trailing arm truck

I'm just wanting to go as low as I can with the factory floor. When the diff hits that's all I want