[grif]

Thanks for the replies, fellas. I finally had a chance to get out to the shop to have a look under the hood. I was able to locate the battery alternator junction which is a little different on my Painless wiring harness, but I did find it.

What's the best way to splice in the wire that runs to the no. 2 terminal on the SI alternator? I have four wires there already (see red wires in the pic) and I'm adding in a fifth. The Painless harness had the four wires connected within some sort of crimped copper band with heat shrink around it. Five wires is quite a junction, especially when there are some 12 gauges wires in there. Any suggestions on how to make this junction?

Thanks!