Tonight I started by removing the nerf bar plates on the passenger side. I will have to do some metal work later on, but not now. I can get clear access to this once the truck is up and running again so it is for another day.
Next was removing the remainder of the brackets. These two muffler brackets were next on the list. I mounted the tailpipes to a different location and they were no longer needed.
Tomorrow I am going to wire wheel the frame and inside of the floor to prepare it for paint. Magnet Chassis Saver and then top coat it. That will let me run the new EFI fuel line and brake line on clean rails. My objective is to get this truck running by the end of June.