View Single Post
Old 12-02-2016, 10:39 AM   #30
reaper71
Registered User
 
reaper71's Avatar
 
Join Date: Nov 2011
Location: West Plains Missouri
Posts: 2,088
Re: Matt's 74 Bronco

Pic #1. On the list for yesterday was getting the seat pan flat or (flat-ish) So my solution was to cut the upper section (piece on left)
By doing this it helped to get it to lay flatter,followed by the tractor weights to help force it down.

Pic #2. This was after the 2 braces were welded to the pan and ready to mockup.

Pic #3. I had to prep all the panels on the edges for welding and here it had a patch to be taken care of.

Pic #4. The passenger side floor pan welded in (on the rails Eastwood encapsulator was used before welding)

Pic #5. The drivers side was also installed and now ready for the seat pan.

Mark...
Attached Images
     
reaper71 is offline   Reply With Quote