The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

daverod · 04-04-2009, 03:21 PM

I rented it from pro rental. They said it was 10 cfm. When I went to pick it up it looked just about like the one I had 5.2 cfm single stage. I rented it anyway, hooked the two together seems to work fine. They run all the time but I can only blast for about 10-15min then I have to fill up my tank. It only holds 40lbs. I just have to do the bottom and I done. So far it's taken about 3hrs and 300 lbs of sand. I'm reusing the sand so I have to screen it. Tomorrow I'm going to do the doors and hood. Have to see if I can get my frame done today also. Its funny I started with 300 lbs and now it's hard sweep up 40lbs. I'll have to check my rockers.

04-04-2009, 03:21 PM	#22
daverod SSN 706 Join Date: Mar 2009 Location: Pocatello Idaho Posts: 3,821	Re: Daverods project 66 I rented it from pro rental. They said it was 10 cfm. When I went to pick it up it looked just about like the one I had 5.2 cfm single stage. I rented it anyway, hooked the two together seems to work fine. They run all the time but I can only blast for about 10-15min then I have to fill up my tank. It only holds 40lbs. I just have to do the bottom and I done. So far it's taken about 3hrs and 300 lbs of sand. I'm reusing the sand so I have to screen it. Tomorrow I'm going to do the doors and hood. Have to see if I can get my frame done today also. Its funny I started with 300 lbs and now it's hard sweep up 40lbs. I'll have to check my rockers.