Quote:
Originally Posted by jbclassix
Do you have the linkage between the two rods? There are interlock pins between the rods, they prevent the rods from moving out of sync from each other. If you are in 4-Low, then both rods should move out at the same time to NEUTRAL. then the top rod should move out one more time to 2-HI, then the bottom rod should move out one more time to 4-HI.
If you are trying to get the top rod into 2-HI with the bottom rod in 4-LOW then it will not go because of the interlock pins.
|
Video looks good on this end!
Yes I do have the linkage between the two rods.
Each one is in each side and there is a single rod between the two in the center to the shifter linkage.
Does that sound correct?
Maybe I should remove the front driveshaft then try to disconnect the linkage and try to move it the way that you did in the video?
Thanks for being patient with me.