Next remove the 2/4 servo assembly
Remove the snap ring holding the servo cover. There are two places in the case which will allow you access to this snap ring. Simply use a screw driver and pry up on this snap ring and remove it
Use a set of channel locks and twist the cover out far enough to have access to the cover o-ring, take a small screw driver and get under the o-ring to cut the o-ring (see pic) pull on one end of the o-ring to remove the o-ring from the cover. Once O-ring is removed. Pull the servo assembly out of the trans case
Posted via Mobile Device
Last edited by YoungPup1977; 04-14-2018 at 12:29 AM.
|