|
Re: Over 25 Years Later, Finally My 71 C-10 Truck Build
When I was removing the rear axle I needed to disconnect the line. The hard line twisted with the nut, so I had to cut it and replace.
This morning I made up some aluminum fuel lines from the pump to the regulator and carb. My first attempt at making hard lines for this, so hopefully it doesn't leak. I used brass compression fittings for a couple joints, flared the one end for the fuel pump, and will need to use a small piece of rubber tube connecting to the carb, at least for now. Pic later.
I got the mounts on and power steering pump on. I'm going to wait to install the engine until I get back from Mexico (work trip) next weekend.
|