Quote:
Originally Posted by edflores
Fantastic job. What did you use for the fittings coming out of the compressor?
|
I used the factory "roto-lock" fitting on the inlet side with a little brass cap to plug the little hole on it.
On the outlet side I used a 3/4" npt female to 1/2" npt female reducer (had to trim the bottom to clear the bolt heads on the compressor) and then a 1/2 npt male to 3/8" line elbow.
Eventually I'll get the 1/2" npt to rotolock fittings that Kilby sells just to clean it up a bit.