So I pulled the front clip yesterday... Also pulled the bulkhead harness out to clean it up and sort out whats there. I want to run some relays for the headlghts.
Today I pulled the old motor/trans/xfer. Pulled both crossmemebers and wire wheeled the frame where the new engine mounts will go. I aso cuts rivets for the bumpstops and removed them, pulled the brake and fuel lines, cut off all the bracketst the PO welded to the frame for exhaust.... I now have a clean slate to work with.... here are some pics....
out with the old... (my buddy Russ guiding it)
ready for the new(er) ...
After these pics I removed the gas pedal, cleaned the 5lbs of crap out of the fresh air vent at the footwell, trimmed the steering column bracket to clear the Hydroboost bracket and removed the e-brake cable. I will be running a hand e-brake lever in the center console I'm building....