Here some more progress on my Floor.
First of all, I am still debating on whether
to incorporate the jack handle stamping into
my new floor pan. Of course I would weld
this in under the rear seat. It is the only
solid section in the original floor.
I finally got the big gap closed between the toe panel
and the new floor pan.
The reason this was such a problem. Is the original welds
in the toe panel was not welded very good from the factory.
Maybe a Friday evening or Monday morning (production line) thing.
About 6" up the toe panel and 14' across the bottom there
was a 1" gap when I pulled the floor mat out.
This caused the cab to settle over time.
I have it all Squared Up and fitting again Finally.
.