The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - Installing junction box for battery needed connections

focusedontheprize · 05-22-2019, 07:54 AM

I recently rebuild the engine harness in my 1987 Chevrolet V30. My goal is only have one wire running to each terminal on the battery, however with the newer accessories (H4 upgraded headlight harness, HD power window kit upgrade, etc.) I am finding this may be a challenge because all of these accessories are required to draw power from the battery.

I was going to install a Stud Type Plastic Junction Box in the engine compartment to run all these connections there. Is this how people are handling these type of situations?

Any tips or recommendations - I am all ears. Thanks everyone.

05-22-2019, 07:54 AM	#1
focusedontheprize Registered User Join Date: Feb 2012 Location: CA Posts: 846	Installing junction box for battery needed connections I recently rebuild the engine harness in my 1987 Chevrolet V30. My goal is only have one wire running to each terminal on the battery, however with the newer accessories (H4 upgraded headlight harness, HD power window kit upgrade, etc.) I am finding this may be a challenge because all of these accessories are required to draw power from the battery. I was going to install a Stud Type Plastic Junction Box in the engine compartment to run all these connections there. Is this how people are handling these type of situations? Any tips or recommendations - I am all ears. Thanks everyone. __________________ "Dixie" - 1988 Chevrolet V30 CC DRW "3+3" \| 7.4L 454 (L19) \| TH400 \| 4" lift \| 35"s "Lucille" - 1949 Chevrolet 3100 (on hold)