[HO455]

The follow up to the previous post. The factory index holes measured 11/16" (photo 1) and the Moogs were 23/32" (photo 2). The index rivets were 19/32" in diameter (photo 3). That means with the replacement shafts there is 1/8" of slop forward and back. After I had it assembled I had to remove the passenger side shaft in order to grind the cap screw down a 1/16" as it was holding the shaft away from the saddle. I did the same to the other side before assembling.
A couple of things I noticed when doing this. One is as the lower control arm moves forward it changes how the brake hoses flex and I had to tweek the brackets on the cross member to keep the hoses from rubbing when the wheels are hard over. In addition I had to move my sway bar frame mounts forward 3/4" to keep the ends of the factory sway bar from rubbing on the airbags.