Quote:
Originally Posted by kwmech
If you are just installing a posi and using the gears over, do not change the pinion depth. A back lash reading should have been taken prior to. If that is correct, .007 may be too tight on a used gear set and create a whine. Try it but you may have to increase the back lash by a few thou. Could as easy as swapping a .003 shim side to side
|
It is a 10 bolt that was narrowed and new moser axels were made...I then bought the project...the pinion and carrier were in the rear end but im not sure of their history etc...I pulled the gov loc carrier adn put in a yukon posi...shimmed to .007 and left the pinion alone...so you think i should widen up the backlash a bit?