|
Re: Glock's new project: "Fred"
This morning, my son and I went to the shop and tinkered for a bit.
I got the rear end pulled out of the burb. This rear has 3.42's and will work beautifully with the 5.3/4L60E combo. I need to get axle seals and bearings, and a pan gasket. Then when the time comes, I'll swap the backing plates off of Fred onto this rearend.
Also got both rear wheel well lower rear pieces of sheet metal cut out. This body is very solid, so these saved my about $80 in patch panels. I'll weld these in this winter while the bed is off doing the engine swap.
|