The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

**chevy_man5** · 08-31-2011, 07:50 AM

Thank you again Mark! Lengthwise I am good then. That leaves me 3' (ish) to move around the truck.

Captainfab, if you can get that measurement I would appreciate it. If not, I will message the guys you talked about. I don't want to take the tires from her truck, because she was actually my step-daughter, so I'm sure they would think it was stealing from them. I'm sure I can find a set of short tires around here somewhere though, if it is close to fitting. I thought about taking the front tires off, roll it in on a jack, and then put them back on, I can make it work, as long as I have enough clearance once inside.

My truck is stock height, with 31/12.5's if I remember correctly. The front springs were replaced with new stock specs, again if I remember correctly.

I haven't really left the board, just haven't had anything to post. LOL Sitting around twiddling my thumbs for the most part. Been itching BAD to get dirty again!

08-31-2011, 07:50 AM	#13
chevy_man5 GMC's n H.D.'s too! Join Date: Oct 2010 Location: Nampa, Idaho Posts: 1,583	Re: '60 GMC 4x4 Long Fenderside Thank you again Mark! Lengthwise I am good then. That leaves me 3' (ish) to move around the truck. Captainfab, if you can get that measurement I would appreciate it. If not, I will message the guys you talked about. I don't want to take the tires from her truck, because she was actually my step-daughter, so I'm sure they would think it was stealing from them. I'm sure I can find a set of short tires around here somewhere though, if it is close to fitting. I thought about taking the front tires off, roll it in on a jack, and then put them back on, I can make it work, as long as I have enough clearance once inside. My truck is stock height, with 31/12.5's if I remember correctly. The front springs were replaced with new stock specs, again if I remember correctly. I haven't really left the board, just haven't had anything to post. LOL Sitting around twiddling my thumbs for the most part. Been itching BAD to get dirty again! __________________ Jason 1960 GMC 4x4 Babe (the Blue Ox) - Build Thread