The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

cleszkie · 10-26-2017, 04:15 PM

Tomo - I haven't done a write-up. Its a pretty simple installation. The Gear Vendors bolts onto the back of the NP205 with an adapter (only have overdrive/underdrive in two wheel drive). I used a CV joint with a 300 series slip yoke out of a Cadillac to keep things as short as possible when building the rear driveshaft. The driveshaft is relatively short, especially with the larger 14 bolt rear axle, but it has a pretty small angle in the CV joint because I don't have a big lift. Runs smooth.

10-26-2017, 04:15 PM	#7
cleszkie Registered User Join Date: Feb 2003 Location: Santa Ana, CA Posts: 2,191	Re: Blazer offroad/ Camping Accessories Tomo - I haven't done a write-up. Its a pretty simple installation. The Gear Vendors bolts onto the back of the NP205 with an adapter (only have overdrive/underdrive in two wheel drive). I used a CV joint with a 300 series slip yoke out of a Cadillac to keep things as short as possible when building the rear driveshaft. The driveshaft is relatively short, especially with the larger 14 bolt rear axle, but it has a pretty small angle in the CV joint because I don't have a big lift. Runs smooth.