The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - Rewired 70 C10 heater and running lights on even if ign is not plugged in.

C10Coloradoguy · 08-26-2017, 06:51 PM

So the hazard fuse was blowing because I had the knob pushed in so the hazards were "on". I pulled out the knob to turn the hazards "off", reconnected the battery and the hazard fuse held. I turned the key to the first position to test the turn signal and when I pushed up on the lever for a right turn signal, the Turn Signal fuse popped. I checked both flashers and I think they're ok but I'm not sure. Going to start tracing wires again.

08-26-2017, 06:51 PM	#25
C10Coloradoguy Registered User Join Date: Jul 2017 Location: Highlands Ranch, CO Posts: 39	Another update... So the hazard fuse was blowing because I had the knob pushed in so the hazards were "on". I pulled out the knob to turn the hazards "off", reconnected the battery and the hazard fuse held. I turned the key to the first position to test the turn signal and when I pushed up on the lever for a right turn signal, the Turn Signal fuse popped. I checked both flashers and I think they're ok but I'm not sure. Going to start tracing wires again.