Quote:
Originally Posted by dsraven
yeah, good idea. before you undo the fitting maybe check to see if it is bottomed out on the hex part where the wrench goes. if so maybe the bore in the rack is deeper than the fitting so the oring doesn't stand a chance of sealing. just a thought. some of the p/s fittings I have seen have a teflon o ring which stands up better than the black rubber ones.
|
Well ..... if I had to guess I would say the hex was bottomed and maybe the seal wasnt fully seated (depth). Hard to be sure.
In the end i threw on a 2nd oring and used the thread sealant here (says hydraulic)
http://shorturl.at/boLOP
No more leaks ...... and can turn the wheels on the ground easily with single hand.
Will monitor and update.
thanks for help/ideas dsraven