The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

'69 Gmc · 02-16-2018, 12:33 PM

The only valves I can find that have the .260 groove to tip like the Vortecs came with are stainless. Are the stainless the way to go? Can I use stainless with the same valve seals?
When I seen the under side of the rockers, that don’t look good. Do they need replaced as well?

Measure lifter? I don’t have any that were in the motor. I have my new ones that I got with my xe268 cam.

I did mic the cam that was in the motor. Seems to be the stock crate cam. Around .400 valve lift
Posted via Mobile Device

02-16-2018, 12:33 PM	#6
'69 Gmc Registered User Join Date: Feb 2016 Location: Columbia TN Posts: 145	The only valves I can find that have the .260 groove to tip like the Vortecs came with are stainless. Are the stainless the way to go? Can I use stainless with the same valve seals? When I seen the under side of the rockers, that don’t look good. Do they need replaced as well? Measure lifter? I don’t have any that were in the motor. I have my new ones that I got with my xe268 cam. I did mic the cam that was in the motor. Seems to be the stock crate cam. Around .400 valve lift Posted via Mobile Device Last edited by '69 Gmc; 02-16-2018 at 12:42 PM.