The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

**Blue/72** · 10-18-2016, 03:18 PM

Here is what I did

1. Power washed the engine bay
2. Pulled the engine and whole front clip
3. Re-power washed and degreases the front frame and suspension
4. Powder coated the inner fenders, core support, battery tray and hood hinges
5. Wire wheeled and cleaned up the frame
6. POR-15 the frame and then painted satin black over that
7. Buffed and waxed the firewall and inside the front fenders
8. Re-installed all the parts and pieces

10-18-2016, 03:18 PM	#16
Blue/72 Senior Member Join Date: Aug 2014 Location: Sandy, Oregon Posts: 2,373	Re: How would you clean up this engine bay Here is what I did 1. Power washed the engine bay 2. Pulled the engine and whole front clip 3. Re-power washed and degreases the front frame and suspension 4. Powder coated the inner fenders, core support, battery tray and hood hinges 5. Wire wheeled and cleaned up the frame 6. POR-15 the frame and then painted satin black over that 7. Buffed and waxed the firewall and inside the front fenders 8. Re-installed all the parts and pieces Attached Images __________________ My dad always says that HEI distributers are pointless... •1972 Custom/10 Deluxe. My first truck and I've had it since I was 7. Tilt, tach, AM/FM, 350, deep dish rally's, original paint and an increasing amount of NOS jewelry. It's always taking my money.. •1967 c10 with tach, dropped 3/5 on deep dish rally's •1972 Cheyenne Super. Sold