View Single Post
Old 03-27-2017, 07:54 PM   #354
Registered User
slowcpe's Avatar
Join Date: Sep 2013
Location: Evansville, IN
Posts: 1,731
Re: '67 Stepper "Laymond"

The stiffener wasn't too bad. Just had to remove about 1000 more rivets and drill a few holes. I'm finding the best way to drill holes in the frame is a small pilot hole and then move to a step bit. I still need to tighten it all up but figured I would spend most of a day to align the whole chassis.

I'm expecting a little bit of a rake due to the dropmember and c-notch. I like that look but Porterbuilt said I can limit the front end to level it out if I want. I considered a Level 1 rear but didn't want to fool with a 2-piece driveshaft.
1967 Red Stepside..."Laymond"
1972 Medium Olive SWB-Chester
1967/71 Blue SWB C10..SOLD
1977 SWB grandpa's.....never should have sold
slowcpe is offline   Reply With Quote