Quote:
Originally Posted by Dead Parrot
From your original post, you are on the 2nd HEI distributor, since you said you replaced the distributor. Was the 2nd one known to be good or just one that 'was laying around?'
What is the voltage to the distributor? HEI wants a full 12V. No resistor wire or ballast resistor. Possible a PO missed that when they swapped out the points setup.
|
Yes the second distributor was brand new. Voltage to the distributor is 12v but drops to 7-9v while cranking. But the starter is bad because it cranks very slow then fast then slow again. Maybe it's drawing too much power?