[url=https://flic.kr/p/2hFLei7]Screenshot_2019-11-05-17-09-54.jp
got to play with my trans. cooling lines today, didn't think they would fit, so I cut them in half, plan to use compression fittings in 5/16" size, my only problem was my splice was right above my crossmember, made it difficult to work on
start by finger tight, then put a wrench on it after your sure the threads are started correctly
getting ready to make some noise, working on trans. pan as first attempt was wrong. weldable bungs should be here tomorrow, then I can put in sender for the trans. temp unit, and drain plug