The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

jaros44sr · 11-13-2019, 08:44 PM

[url=https://flic.kr/p/2hKo2sg]Screenshot_2019-11-13-15-45-22.jpg

paint later, drive shaft installed, what a PITA the 4 bolts to the CV joint, upside down and backwards. had to drop exhaust pipe for clearance to work

[url=https://flic.kr/p/2hKo2sG]20191113_133528

seems the forward location was best for the trans. temp. sender, maybe use the bungs for cooling lines later, at least I have a drain plug or two

[url=https://flic.kr/p/2hKo2EA]20191113_133617

trans. cooling lines done, fill her up with fluid. picked a rather difficult spot to make splices, right above crossmember

Now, to work on brake lines

11-13-2019, 08:44 PM	#3171
jaros44sr Registered User Join Date: May 2006 Location: Philadelphia, Pa. 19454 Posts: 9,421	Re: PO has me PO'd [url=https://flic.kr/p/2hKo2sg]Screenshot_2019-11-13-15-45-22.jpg paint later, drive shaft installed, what a PITA the 4 bolts to the CV joint, upside down and backwards. had to drop exhaust pipe for clearance to work [url=https://flic.kr/p/2hKo2sG]20191113_133528 seems the forward location was best for the trans. temp. sender, maybe use the bungs for cooling lines later, at least I have a drain plug or two [url=https://flic.kr/p/2hKo2EA]20191113_133617 trans. cooling lines done, fill her up with fluid. picked a rather difficult spot to make splices, right above crossmember Now, to work on brake lines __________________ Semper Fi...Uncle Sam, you da man All parts offered to help are free, unless otherwise noted Dont try this stuff in my build thread, unless you have 55 years of mechanical OTJ training SAFETY FIRST AS usual, off topic They say your mind goes second, can't remember the first Jim Last edited by jaros44sr; 11-13-2019 at 08:54 PM.