The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

jgammill · 08-22-2012, 03:41 PM

I made the rear frame section to support the back of the bed and connect the fram together.

Then I made up my rear drive shaft and installed it. Had to order the front shaft with 1410's because it is at more of an angle than before.

Next was to get the exhaust done. I had to do a 2 into 1 because of clearance issues with the tcase. Running a offroad Flomaster 40 series muffler with it turned down. You can also kinda see the rear support I made for the back of the NP205. Just used a leaf spring bushing and built a bracket coming off of the crossmember in front of it.

Now I'm preping the cab so I can set it on tonight. Going to have to cut alot of the floor out so the tranny and cases can set up higher.

08-22-2012, 03:41 PM	#7
jgammill Registered User Join Date: Jul 2011 Location: chattanooga, ok Posts: 137	Re: Project: GOOBER, 1971 GMC I made the rear frame section to support the back of the bed and connect the fram together. Then I made up my rear drive shaft and installed it. Had to order the front shaft with 1410's because it is at more of an angle than before. Next was to get the exhaust done. I had to do a 2 into 1 because of clearance issues with the tcase. Running a offroad Flomaster 40 series muffler with it turned down. You can also kinda see the rear support I made for the back of the NP205. Just used a leaf spring bushing and built a bracket coming off of the crossmember in front of it. Now I'm preping the cab so I can set it on tonight. Going to have to cut alot of the floor out so the tranny and cases can set up higher.