[Thebrownturd]

Here is the pictures with the 2" lift on the front with ORD's grease-able bushings . It raised the truck a total of 4 1/2" in the front. I believe it was due to the fact that the rubber bump stocks were almost resting on the axle. Lets just say the old springs were well used. I used the 3" spring on the back to try and keep the truck level but, the rear only came up about 2" from where it was, even with the factory block back in place. I think all i need is a little taller block which is ok since I need to reset the pinion angle to get rid of the small drive line vibration i have developed.

All I need is to find some gas tank doors for the bed. They are the aluminum Travel Tanks doors but i cant reuse the old ones i pulled off since they were all bent up. Anyone know if there is a replacement source. Seems like quite a few people are able to get them.