[Bob Moore]

There is a ton of information shared on this site. It would help if members would read what others have posted. Maybe you could answer your question before posting it.

If you have not purchased a "Factory Assembly Manual" and a "Factory Shop Manual", I strongly advise you to do so.

This comment is not directed at smokenbarrels. As posted by FarmTruk and Slammed66, measure your frame diagonally. The 2nd from rear is mounted "non-square" and plays tricks on your eyes. You should not have a problem when you shorten your frame if you take care and double check and triple check your measurments before you cut.