|
Re: I could use some Quadrajet Guru help
No body has mentioned the metering rods. The pri. metering rods must move down with slight pressure & pop right up with out the pressure. You need to check the float. Set it down in some gas or solvent. It should bobble like a cork. If there is any dought replace it. They are not expensive. Make sure to match the old one as there are several different ones. The brown stuff you mentioned on the bottom of the wells are e-poxy that someone has all ready sealed them with. If it restarts as easily as you say you have no problem in that regards. Make sure you use the float level speck to match the carb nimber.
|