The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

Jacfourteen · 04-05-2011, 01:43 PM

So I got a little more done, first I did a bunch of grinding. Man I hate grinding, but I guess it's good practice for when I start the bed as I've never done any body work. I had to reweld a few spots where there was some low spots and touch up where I welded up some of the holes in the frame. So here's a few pics of the progress during the process:

I also got some paint done so I'll post up the pics of that soon!

04-05-2011, 01:43 PM	#25
Jacfourteen Big Red - Now its a SWB! Join Date: Jun 2009 Location: Oroville, Ca Posts: 1,624	Re: Big Red, my 68 3/4 ton GMC So I got a little more done, first I did a bunch of grinding. Man I hate grinding, but I guess it's good practice for when I start the bed as I've never done any body work. I had to reweld a few spots where there was some low spots and touch up where I welded up some of the holes in the frame. So here's a few pics of the progress during the process: I also got some paint done so I'll post up the pics of that soon! __________________ 68 3/4 ton (Project)-350 Small Block, .030 over, 10:1 comp, 3998993 heads, C3BX edelbrock intake, comp cams XE268, Holley 670 SA, long tube headers, dual flow 40's, E-fan, Alum rad, currently under the knife getting shortened and bagged build thread 41 3/4 ton (wife's)-flatbed, fully restored to original 01 Tahoe LT 4WD (my daily driver)-Magnaflow Muffler, Rollin on 22's 02 Ford Mustang Convertable (Wife's Car)-Flowmaster 50, Clear corners, Intake, sittin on 18's