And lastly here is a short clip of starting the engine a couple weeks back.
Basically it needs a hot wire and ground to the glow plug relay box. Then another wire that would be hooked to a switched 12v that turns the relay on and off via the key or in my case its going to be a push button hidden somewhere (since it wont easily start without glowing first, sort of a reverse kill switch)
Other than that, a lead to the starter and an engine ground and were making a lot of noise and going no where slow.
obviously has no exhaust, and I had no water in it, I just wanted to verify it would start and idle before I went any further. All seems well there.