[clinebarger]

Valve Body...

It is very important your work area is clean, Any Valve or Valve Bushing needs to be cleaned as well as the Bore it is removed from. I use a Solvent Blow Gun & New Clean Solvent, Blowing Solvent is hazardous to your Lungs.

Always place your finger over the hole a Bushing/Valve is in when removing a Roll Pin, The 700 isn't to bad about this (The 3-2 Spring IS), Just a good habit.

Let's start with the MOST important part (And gives the most issues) The TV Valvetrain.

Remove the TV Plunger Bushing Roll Pin.

Remove Plunger & Bushing, Use the Plunger Valve as a slide hammer to remove the Bushing, Use fingers, Not Pliers, Dykes or any other tool if you plan on reusing the Plunger or Bushing. New "94 Code" Plunger assembly is a recommendation.

Remove TV Spring.

Remove TV Valve Roll Pin. See Pic.

Remove TV Valve.