Quote:
Originally Posted by hemi43
Most likely the shim thickness that you took out of the original pinion will be within a few thou of what you need. At least that's been my experience in the past. I can't recall if you mentioned that you were reusing the original gears or buying new, but my first choice is Yukon. Richmonds are a bit cheaper, but I guess you get what you pay for because I've had some sets squeal like a stuck pig even though the pattern was dead on. Good luck and keep posting pics.
edit; I guess I should have read your previous more thoroughly because I now realize you already made a setup bearing !
|
Thank you for taking the time to comment, I'm kind of flying blind here and reliant upon others knowledge and advice. I'm glad you are reinforcing the information I have picked up so far, it is reassuring.
Thank you again!