I was able to get out in the shop again this morning. I've had the stainless trim that goes around the 54 windshield for a while, but I can NOT find the clips that go where the ends come together.
I knew I had some left over stainless trim from the Jeep build,
IMG_0027 by
Robert Moorman, on Flickr
so I cut it into two pieces, trimmed it up and worked on it with a small hammer and a pair of needle nose pliers to "roll" the edge on.
IMG_0028 by
Robert Moorman, on Flickr
I have some more work to do on it, like smoothing up the edges, working on the width a little and then polishing all the stainless, but I think these will work.