The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - Tackling a botched build, need SBC advice.

BR3W CITY · 08-04-2017, 11:30 AM

Ok, the thing where an idle screw WOULD be, is the thing I had to use. It refused to stay running without it. FiTech says that the IAC is on the drivers side...this was on the passenger.

Going back to the fact that this FiTech is just.....just...bad. Had to read 30 threads on all of the vent and return line problems, figure out why the internal pump was all over the place (the PWM control apparently). I'm seriously considering just going and slapping a parts store 650 on this thing so it runs.

08-04-2017, 11:30 AM	#11
BR3W CITY meowMEOWmeowMEOW Join Date: Sep 2009 Location: MKE WI Posts: 7,128	Re: Tackling a botched build, need SBC advice. Ok, the thing where an idle screw WOULD be, is the thing I had to use. It refused to stay running without it. FiTech says that the IAC is on the drivers side...this was on the passenger. Going back to the fact that this FiTech is just.....just...bad. Had to read 30 threads on all of the vent and return line problems, figure out why the internal pump was all over the place (the PWM control apparently). I'm seriously considering just going and slapping a parts store 650 on this thing so it runs. __________________ *'66 Short Step / SD Tuned / Big Cam LQ4 / Backhalfed /Built 4l80e / #REBUILDEVERYTHING* MY BUILD THE H8RDCPTR //\\ MY YOUTUBE CHANNEL REV J HD Last edited by BR3W CITY; 08-04-2017 at 11:37 AM.