Quote:
Originally Posted by Rickysnickers
I bought one, but have had issues with it, which I'm sure are operator error. In the photo above, one of the guys uses clamps on the master cylinder. I tried that and still had brake fluid going all over the place. It was a huge mess. I still think there is air in the lines somewhere too, as my brake pedal goes to the floor, when driving. If I pump it a couple of times, it comes back. If any of you are wondering, no I haven't driven it much at all in this condition.
|
I put a very small amount of grease on the mating surface to help seal. Then put two c clamps on it and pump up with just air at first to check for leaks. Once you fix leaks then add fluid and bleed