[highwinger]

Here's some pics of the areas of noticeable improvement. During the install, the rubber snapped into channel well with a bit of soapy water and it didn't pop out like the previous brand. Pic #1 shows the fit around the pivot bracket. The CP gasket already had the cutout where I had to figure it out with PRP's. Pic #2 shows the how well the two pieces fit together. And last but most importantly, Pic #3 shows the fwd bend area fit. I used a clamp to help snap that section into the channel. Once it was in, it stayed put. The wing didn't pull it out of the channel like with PRP's. Success at last.

Now on to the driver door, then the second seat windows...