Thanks guys, I finally got my computer, wiring harness, and fuel pump in yesterday.
Decided to finish the A/C and alternator mounts before I start on the FI wiring and fuel system. I cut a hole in the A/C mount for the heater hose as I showed in a previous post and built a new belt tensioning device because the old one was ugly and awkward to use. The new one is a piece of aluminum 5/8" hex rod with 3/8" rod ends. The alternator mount is a new one from Alan Grove and required quite a bit of shimming and tweaking to make the belts line up. I am going to drill a hole in the front plate on the A/C mount to make it look a little more "SPORTY" and cut an arc in the alternator mount to make it easier to check/fill the power steering reservoir.