[getbent]

well been working as much as possible on the truck, got alot done this week
got my wiring started, all 1/0 grounnds and power leads[IMG]

http://img813.imageshack.us/img813/7897/pa090317.jpg[/IMG]
By grasshoper at 2010-10-10


By grasshoper at 2010-10-10

300 amp fuses, laying the ground work for the stereo system


By grasshoper at 2010-10-21

fuses mounted, on some scrap aluminum , put some detailinng into these with a wire brush trying to achieve a scalloped look

also wired up the controller for the twin e-fans, and mounted the radiator and fans permmanently! no more mock up


By grasshoper at 2010-10-21

all the stainless braid hoses are going in, magna clamps on the ends, looks real clean


By grasshoper at 2010-10-19

drive shaft went in after being shortened by 2 inches, balanced and new carrier bearing, and all new heavy duty u joints


By grasshoper at 2010-10-19


By grasshoper at 2010-10-19

some more pics of the install, I know im all over the place on this but theres so much to show,


By grasshoper at 2010-10-19

had to massage the header with a bfh to gain clearance for steering shaft
By grasshoper at 2010-10-10


By grasshoper at 2010-10-19

so to sum it up the motor and tranny are in and all the plumbing is on , gonna work on the wiring harness, and then replace the stock gauge cluster with a set of autometer gauges , lots more work to do but lots of progress made stay tuned for more pics and maybe a little video.

give me some input, dont just look give me some feadback!! good , bad , or even ugly!!!