[Cape Codder]

To adjust a door with welded hinges instead of jacking the door and possibly denting or bending it the other option is to open the door and put a block of wood in the open part of the hinge where the pin is and GENTLY close the door until the hinge hits the block. Then apply some pressure and check. Go easy it is easy to go to far. By binding the hinge it will bend it back and raise the rear of the door. The idea is to have an even gap at the rear or the door and the body lines at the rear aligned. The fender to door gap is aligned with the fender. If the whole door seems low before doing anything loosen the door to hinge bolts and see if the whole door will come up a little.
Doors should be aligned with the striker removed and should fit without the striker influencing it.