The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

**clay68c10** · 06-23-2020, 10:08 PM

It's sitting back right side up on the casters!

Of course, the motivational shot of the panels just set on it.

And a back side shot of the corner. I chose to cut it here so I could get to the back side of the weld and make sure it doesn't have any pinholes. It wasn't real crusty up this high, but I'd rather be able to get to both sides of the weld seam.

06-23-2020, 10:08 PM	#120
clay68c10 Senior Member Join Date: Aug 2004 Location: Centennial, CO Posts: 2,897	Re: ClusterTruck; because that’s what it is It's sitting back right side up on the casters! Of course, the motivational shot of the panels just set on it. And a back side shot of the corner. I chose to cut it here so I could get to the back side of the weld and make sure it doesn't have any pinholes. It wasn't real crusty up this high, but I'd rather be able to get to both sides of the weld seam. Attached Images __________________ ClusterTruck: 68 C10 Bought in 89, wrecked in 03. Slow low $ rebuild started '17. 6.0 & TKO http://67-72chevytrucks.com/vboard/s...d.php?t=788602 93 K1500 Short Step, 350, NV4500, EBL flash ECU. Vortec heads & roller cam someday... 05 Jeep Wrangler Unlimited. 3” lift & 6-speed 02 E320 the insurance total “free car” 13 Tahoe LTZ Last edited by clay68c10; 06-28-2020 at 01:41 PM.