[73737373]

The Dremel worked great, but couldn't get the cab seperated far enough from the frame to slide the new bushing and shims in the front. UGH!!! I have an extra rear cab mount bushing and was able to successfully slide that one in in the front plus reuse the shims (mine had 2), but the bushing that's supposed to go in like in the picture above, simply would no go in. I'm going to loosen the rear mount on the same side and jack up the cab again and see if that works. I need about another 1/8 of an inch of clearance, and even w/that, will still have to hammer in the shim(s). That's as far as I got late Wed afternooon when it was 70 degrees and sunny. Rained yesterday and more of the same for today, Sat and Sunday, so it will sit for a while until the weather warms up.