[N2TRUX]

With the upper mounting bracket secured in place I was able to start hanging parts. The upper ball joints are bolted to the upper A Arms. The A arms are stamped with a D & P for obvious reasons. Even though they look the same, especially late at night, they must be mounted on the correct side.

With the upper arms in place you can move to the lower A arms. Fortunately the lower ball joints come pressed in place. The factory U bolts are used to mount the lower arms. I bead blasted them to clean up the old threads, then gave them a coat of satin black.

I found that the bolts had spread wide and didnt want to fit back in the holes properly. I installed the nuts to protect the threads then gave them a few whacks with a hammer till they fit properly. Also note that the lower arms have a guide pin to align them. Be sure that seated properly while installing the arms.